Hotpoint SE100PX Manuel d'utilisateur télécharger pdf (Page 13)

Automatic cleaning with the FAST

CLEAN function

With the FAST CLEAN mode, the internal temperature

of the oven reaches 500°C. The pyrolysis process is

activated and burns away food and grime residues.

During the automatic cleaning cycle, the surfaces may

become very hot. Keep children away from these.

Particles may ignite inside the oven due to the

spontaneous combustion process. Do not worry, this

process is both normal and hazard-free.

Before initiating the FAST CLEAN mode:

 Remove large or course food residues from inside

of the oven using a damp sponge. Do not use

detergents.

 Remove all accessories.

 Do not place tea towels or pot holders over the

oven handle.

! If the oven is too hot, pyrolysis may not start. Wait for

the oven to cool down.

! The programme may only be started once the oven

door has been closed.

To enable the FAST CLEAN mode press

. Select

the desired FAST CLEAN mode level by adjusting +

and - on the right side of the control panel. The FAST

CLEAN mode has three default time settings which

cannot be modified:

1. Economy (ECO): 1 hour

2. Normal (NOR): 1 hour and 30 minutes

3. Intensive (INT): 2 hours.

Safety devices

 The door is locked automatically as soon as the

temperature exceeds a certain value.

 Should a malfunctoin occur, the heating elements

will switch off.

 Once the oven door has been locked, you cannot

change the cycle time and end time settings.

! Programming is possible only after selecting the

FAST CLEAN mode.

Programme Delayed Cleaning

Press

, then:

1. Set the time using + and - on the left side of the

control panel.

2. Press

to store the setting.

3. Press START to activate programming.

4. When the selected time has elapsed, END appears

on the TEMPERATURE display and a buzzer sounds.

 For example: it is 9:00 a.m. and the Economy (ECO)

FAST CLEAN mode level has been selected:

default set time 1 hour. 12:30 is selected as the end

time. The programme starts automatically at 11:30

a.m.

and blink, showing that programming has

been set. The CLOCK and COOKING TIME displays

show the FAST CLEAN end time and its duration

alternately.

To cancel programming press STOP.

Once the automatic cleaning cycle is over

You will have to wait until the temperature inside the

oven has cooled down sufficiently before you can

open the oven door. You will notice some white

dust deposits on the bottom and the sides of your

oven; remove these deposits with a damp sponge

once the oven has cooled down completely. You

may on the other hand prefer to take advantage of the

heat accumulated to start cooking immediately; in this

case the dust can stay where it is: it is completely

harmless and will not affect your food in any way.

1 2 ... 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint SE100PX Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Fours Hotpoint SE100PX