Hotpoint H250E Manuel d'utilisateur télécharger pdf (Page 5)

Installation

WARNING – THIS APPLIANCE MUST BE EARTHED.

MAINS CONNECTION

Your cooker should have been checked to ensure

that the voltage corresponds with your supply

volt

age,

this is stated on the rating plate, which is situated

on the rear panel. The cooker must be

connected by a competent person such as a NICEIC registered contractor to a suitable double-pole

control unit with a minimum rating of 32A (30A double-pole control switch installations found in

older properties are acceptable) and a minimum contact clearance of 3mm, which should be fitted

adjacent to the cooker, in accordance with IEE regulations. The control unit must be within 2

metres of but not directly above the appliance and should be easily accessible in the event of an

emergency.

The power supply cable should conform to B.S.6004 with a conductor size of 6mm

, minimum.

Access to the mains terminals is gained by removing the rear access cover. The mains cable

must pass through the cable clamp adjacent to the terminal block. Sufficient cable should be

used to allow the cooker to be pulled out for servicing.

Ensure that the mains cable is routed away from any brackets affixed to the rear panel and

is not trapped to the rear wall when pushing the cooker into position between cabinets.

COOKER HEIGHT

Your cooker must stand

on a flat surface so that the hob is perfectly level, and the cooker is stable

and cannot be rocked.

SITING THE COOKER

The cooker is designed to fit between kitchen cabinets spaced 500mm apart. The space either

side need only be sufficient to allow withdrawal of the cooker for servicing. It can be used with

cabinets one side or both as well as in an angled corner setting. It can also be used freestanding.

Adjacent side walls which project above hob level, must not be nearer to the cooker than

150mm and should be

protected by heat resistant material. Any overhanging

surface or cooker

hood should not be nearer than 650mm.

MOVING THE COOKER

Before moving your cooker, switch off at the cooker control unit, ensure that it is cool.

Open the grill door sufficiently to allow a comfortable grip on the underside front edge of the

oven roof, avoiding any grill elements.

Note: Take care in moving the cooker as it is heavy. Take care to ensure that any floor

covering is not damaged.

RADIO INTERFERENCE

This appliance conforms to EN 55014 regarding suppression of radio and television interference.

1 2 3 4 5 6 7 8 9 10 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Hotpoint H250E Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Radio Hotpoint H250E