Hotpoint FTCF 87B 6HY1 EU Mode d'emploi télécharger pdf (Page 3)

Where to install the tumble dryer

If the dryer is installed

below a worktop,

ensure there are 10

mm between the

upper panel of the

dryer and any objects

above it, and 15 mm

between the sides of

the machine and the

walls or furniture units

adjacent to it. This ensures adequate air

circulation.

The appliance must be installed with the rear

surface placed against a wall.

Ventilation

Make sure that the dryer is installed in a room free of

humidity and with adequate air circulation. The flow of air

around the dryer is essential to allow water to condense

during drying; the dryer will not function properly if it is

placed in an enclosed space or inside a cabinet.

Some condensation may form if the dryer is used in a small

or cold room.

Water drain

If your dryer is installed next to a drain the water can be

plumbed into this drain. This does away with the need to

empty the water container. If the dryer is stacked onto or

installed next to a washing machine it can share the same

drain. The height of the drain must be less than 3’ (1 m) from

the bottom of the dryer.

Remove existing hose from position shown in picture A and fit

a suitable length of hose and connect as shown in picture B.

The drain tube has to be below 1 m from the bottom of

the Dryer

Make sure that the hose is not squashed or kinked

when the dryer is in its final location.

We do not recommend that the dryer is

installed in a cupboard but the dryer must never

be installed behind a lockable door, a sliding

door or a door with a hinge on the opposite

side to that of the dryer door.

Electrical connections

Before plugging the appliance into the socket,

check the following:

Make sure your hands are dry.

The socket must have an earth

connection.

The socket must be able to withstand the

machine’s maximum power output as

indicated on the rating plate.

The power supply voltage must fall within

the values indicated on the data plate.

Do not use extension leads. Do not pull the

power supply cable. Do not use multiple

plug adaptors if the appliance is fitted with a

plug. For appliances with fitted plug, if the

plug is not suitable for you socket outlet,

contact a qualified technician.

The dryer must not be installed outdoors,

even if the space is sheltered.

Once installed, the dryer’s electrical wire

and plug must be within reach.

The power cord must not be bent or

squashed.

If the plug being replaced is a non-rewirable

type, then the cut-off plug must be disposed of

safely. DO NOT leave it where it can be inserted

into a socket and create a shock hazard.

The power must be regularly checked. If

the supply cord is damaged, it must be

replaced by service agent . (see Assistance).

H<1m

Picture A

Picture B

10 mm

15 mm

The manufacturer denies any

responsibility should any of these rules

not be followed.

If in doubt about any of the above

consult a qualified electrician.

Preliminary information

Once the tumble dryer is installed, clean the inside of the

drum before operating it and remove any dirt accumulated

during transportation.

Installation

Maximum load: 8 kg

This household tumble drier is a Condenser

The weighted Annual Energy Consumption (AEc)* kWh 1) 560.0

This household tumble drier is a Automatic

Energy consumption full load; Edry - kWh 2) 4.74

Energy consumption partial load; Edry½ - kWh 2) 2.56

Power consumption: off-mode (Po) - Watts 0.14

Power consumption: left-on mode (Pl) - Watts 2.77

Prog. Time - weighted (Tt) full & partial load - minutes 3) 110

Full load (Tdry) - minutes 145

Partial load (Tdry½) - minutes 83

weighted (Ct) full & partial load 3) 81

full load (Cdry) 81

partial load (Cdry½) 81

Airborne acoustical noise emissions - dB(A) re 1 pW 69

Programme time in minute, for program “Synthetics” full load 65

Partial load for program “Synthetics” N/A

Average condensation efficiency - %

1) "Standard cotton” at full and partial load is the standard programme to which the

information in the label and the fiche relates. The standard cotton program is

suitable to dry at cupboard level (0%) cotton laundry and is the most efficient

programme in terms of energy consumption. Partial load is half the rated load.

2) based on 160 drying cycles of the standard cotton programme at full and partial

load, and the consumption of the low-power modes. Actual energy consumption

will depend on how the appliance is used.

3) Weighted average of 3 cycles at full load and 4 cycles at half load.

egulation 932/2012.

Energy consumption in kWh, for program “Synthetics” full load 1.38

Energy efficiency class on a scale from A+++ (low consumption)

to D (high consumption)

Duration of the 'left-on mode' for power management system -

minutes

Condensation efficiency class on a scale from G (least efficient) to

A (most efficient)

roduct Data - Regulation 392/2012.

Brand

HOTPOINT/ARISTON

Model

FTCF 87B 6HY1 (EU)

Rated capacity of cotton laundry for the "standard cotton

programme" at full load - kg

8.0

1 2 3 4 5 6 7 8 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint FTCF 87B 6HY1 EU Mode d'emploi Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Séchoirs à tambour Hotpoint FTCF 87B 6HY1 EU

Powiązane produkty i podręczniki dla Zegar Eton SOUND101