Hotpoint Tumble Dryer Manuel d'utilisateur télécharger pdf (Page 13)

How to remove and clean the fluff filter

Position of filter

To remove the filter

A very important part of your dryer is the fluff filter at

the front edge of the drum. It’s there to trap the

particles of lint and fluff which are normally blown away

when clothes are dried on the washing-line.

if the filter is allowed to become blocked, the passage

of warm air through the drum will be severely restrict-

ed. This means your clothes will take much longer than

normal to dry and the cost of drying them will be

increased. it may also damage your dryer.

Small items, e.g. babies socks, may fall onto the filter.

These should be removed so that the filter is not

restricted.

Grip the centre rib and pull the filter upwards and for-

wards through the door seal (see diagram).

Open the filter, and remove the fluff that has collected

on the inside.

Wash or vacuum clean the filter occasionally.

Don’t be alarmed by the amount of fluff you may find

on the filter. It’s part of the wearing, washing and dry-

ing process.

It is essential that the filter is replaced correctly. It must

be fitted so that the symbols, shown on the filter above,

face towards the front of the dryer. Ensure the filter is

fully located into the tumble dryer duct.

WARNING: NEVER USE SHEET FAB-

RIC CONDITIONER. IT MAY FALL INTO

THE FILTER AND RESTRICT THE AIR-

FLOW THROUGH THE DRYER

WARNING: DO NOT OPERATE THE DRYER

WITHOUT CLEANING THE FILTER AFTER

EACH DRYING CYCLE. FAILURE TO CLEAN

THE FILTER MAY RESULT IN A FIRE HAZARD.

WARNING: DO NOT OPERATE THE DRYER

WITHOUT THE FILTER IN POSITION.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Pas de commentaire

Hotpoint Tumble Dryer Manuel d'utilisateur Page 13