Hotpoint Tumble Dryer Manuel d'utilisateur télécharger pdf (Page 15)

The Controls - TDL30

Timer control

Heat Selection

The ‘Cool Tumble’

phase

Heat Switch (OUT low heat, IN high heat) Indicator

Turn the timer clockwise to select the required drying time. The drying

time for both heat settings is controlled by the timer. All you have to do

is turn the Timer Control clockwise until the required time appears in

line with the indicator.

Never wind the timer control anti-clockwise.

This operation also starts the dryer, provided the door is closed and

the machine is plugged in. The “Guide To Drying Times” section will tell

you how much time you’ll need for various loads.

The button is ‘OUT’ for LOW heat and ‘IN’ for HIGH heat.

The choice of FULL HEAT or LOW HEAT depends upon the fabric you

wish to dry (see section, ‘Sorting your Laundry’)

About 10 minutes before the programme is completed, the heating

elements will be switched off, and the programme enters the final ‘Cool

Tumble’ phase. During this phase, the fabric is cooled. You should

always allow the dryer to complete this phase.

By opening the door, the dryer will stop and you can check the dryness

of the load as often as you wish and, if you want to remove (or add)

some items before they are fully dry. (This is particularly useful for a

mixed load where you want to iron some items,but others to be fully

dried).

We recommend that the clothes are removed immediately the

programme is finished to minimise creasing.

Drying Guide Timer

NEVER SWITCH THE DRYER ‘OFF’ WITH A HOT LOAD IN THE

DRUM. YOU MUST TERMINATE EVERY PROGRAMME WITH THE

COOL TUMBLE PHASE.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Pas de commentaire

Hotpoint Tumble Dryer Manuel d'utilisateur Page 15