Hotpoint FDG 8620 IT Mode d'emploi télécharger pdf (Page 15)

15

GB

Connecting the drain hose

Connect the drain

hose, without bending

it, to a drain duct or

a wall drain situated

between 65 and 100

cm from the floor;

alternatively, placed

it over the edge

of a basin, sink or

tub, fastening the

duct supplied to

the tap (see figure).

The free end of the

hose should not be

underwater.

! We advise against the use of hose extensions;

if it is absolutely necessary, the extension must

have the same diameter as the original hose

and must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the

electricity socket, make sure that:

• thesocketisearthedandcomplieswithall

applicable laws;

• thesocketisabletowithstandthe

maximum power load of the appliance as

indicated in the Technical data table (see

opposite);

• thepowersupplyvoltagefallswithinthe

values indicated in the Technical data table

(see opposite);

• thesocketiscompatiblewiththeplugofthe

washer-dryer. If this is not the case, replace

the socket or the plug.

! The washer-dryer must not be installed

outdoors, even in covered areas. It is extremely

dangerous to leave the appliance exposed to

rain, storms and other weather conditions.

! When the washer-dryer has been installed, the

electricity socket must remain within easy reach.

! Do not use extension cords or multiple sockets.

! The cable should not be bent or compressed.

65 - 100 cm

! The power supply cable must only be

replaced by authorised technicians.

Warning! The company shall not be held

responsible in the event that these standards

are not observed.

The first wash cycle

Once the appliance has been installed, and

before you use it for the first time, run a wash

cycle with detergent and no laundry, using

wash cycle auto clean (see “Cleaning the

washer-dryer).

Technical data

Model

FDG 8620

Dimensions

width 59.5 cm

height 85 cm

depth 60,5 cm

Capacity

from 1 to 8 kg for the wash

programme

from 1 to 6 kg for the drying

programme

Electrical

connections

please refer to the technical

data plate fixed to the machine

Water con-

nections

maximum pressure

1 MPa (10 bar)

minimum pressure

0.05 MPa (0.5 bar)

drum capacity 62 litres

Spin speed

up to 1200 rotations per

minute

Energy ra-

ted

programmes

according to

regulation

EN 50229

Wash: programme 5; tem-

perature 60°C; using a load

of 8 kg.

Drying: the smaller load

(2kg) must be dried by

selecting the “A1” (IRON)

dryness level. The load must

consist of 2 sheets, 1 pil-

lowcase and 1 hand towel;

the remainder of the load must

be dried by selecting the “A4”

(EXTRA) dryness level.

This appliance conforms to

the following EC Directives:

- 2004/108/EC (Electroma-

gnetic Compatibility)

- 2006/95/EC (Low Voltage)

- 2012/19/EU (WEEE)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Commentaires sur ces manuels

Pas de commentaire