Hotpoint EG600P (T) Mode d'emploi télécharger pdf (Page 15)

Routine Maintenance and Cleaning

Before each operation, disconnect the cooker from the

electrical supply. To ensure that the appliance stands the

test of time, it must be thoroughly cleaned frequently, keep-

ing in mind that:

••

• do not use steam equipment to clean the appliance

• the enamelled parts and the self-cleaning panels, where

present, are washed with warm water without using any

abrasive powders or corrosive substances which could

ruin them;

• the inside of the oven should be cleaned fairly often

while it is still warm, using warm water and detergent

followed by careful rinsing and drying;

• the flame spreaders should be washed frequently with

hot water and detergent, taking care to eliminate any

scale;

• In cookers equipped with automatic lighting, the termi-

nal part of the electronic instant lighting devices should

be cleaned frequently (C) and the gas outlet holes on

the flame spreaders should be checked to make sure

they are free of any obstructions;

• stainless steel may become marked if it comes into

contact with very hard water or harsh detergents (con-

taining phosphorous) for long periods of time. After

cleaning, rinse and dry thoroughly. It is also recom-

mended that any remaining drops of water be dried;

• On models with glass covers, the covers should be

cleaned with hot water; the use of rough cloths or

abrasives is to be avoided

N.B.: Avoid closing the cover while the gas burners

are still warm. Remove any liquid from the lid be-

fore opening it.

Important: periodically check the wear of the gas hose

and substitute it if there are any defects; we recommended

changing it every year.

Replacing the oven light bulb

• Before any operation, disconnect the hob from the elec-

trical supply by pulling out the plug or using the switch

that connects the oven to the electricity mains.

• Using a narrow, thin object (screwdriver, spoon handle,

etc.), remove the glass lid.

• Remove the lamp and replace it with one that has the

same properties:

- Voltage: 230/240 V

- power 15W

- E 14 cap

• Replace the glass cover taking care to position the seal

correctly.

coperchio

guarnizione

lampadina

cavità

Gas tap maintenance

The taps may jam in time or they may become difficult to

turn. If so, the tap itself must be replaced.

N.B.: This procedure must be performed by a techni-

cian authorised by the manufacturer.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Hotpoint EG600P (T) Mode d'emploi Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Fours Hotpoint EG600P (T)