Hotpoint S230G DY230G Manuel d'utilisateur télécharger pdf (Page 30)

CONNECTING TO GAS SUPPLY

The oven is designed to be connected with an approved appliance flexible connection to BS 669.

A length of 1.25 to 1.55m is recommended. An adaptor backplate should be fitted in the area

shown to allow the appliance to be pushed fully back into the cabinet. The flexible hose should

be fitted such that it cannot come into contact with moveable parts of the housing unit (e.g. a

drawer) and does not pass through a space where it is likely to become trapped or damaged.

The temperature rise of areas at the rear of the appliance that are likely to come in contact with

the flexible hose do not exceed 70

INSTALLATION INSTRUCTIONS

200mm

630mm

450mm

50mm

CABINETS LESS THAN 565mm DEEP

The appliance can be fitted into a cabinet of

minimum depth 550mm providing a suitable

connection to the gas supply can be made. The

wall behind the appliance will need to be

chased away behind the appliance gas inlet. The

gas connection can either be made with a flexible

hose or 8mm minimum diameter rigid piping,

leading below or to the sides of the appliance.

Where rigid piping is used, an accessible isolation

tap with suitable means of disconnection must

be provided to allow for servicing.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

Hotpoint S230G DY230G Manuel d'utilisateur Page 30