Hotpoint SX 638 CK Mode d'emploi télécharger pdf (Page 11)

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

Switching the appliance off

Disconnect your appliance from the electricity supply

before carrying out any work on it.

Cleaning the appliance

• The stainless steel or enamel-coated external parts

and the rubber seals may be cleaned using a

sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for the

removal of stubborn stains. After cleaning, rinse and

dry thoroughly. Do not use abrasive powders or

corrosive substances.

• The inside of the oven should ideally be cleaned

after each use, while it is still lukewarm. Use hot

water and detergent, then rinse well and dry with a

soft cloth. Do not use abrasive products.

• All accessories can be washed like everyday

crockery, and are even dishwasher safe.

! Never use steam cleaners or pressure cleaners on

the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge

and a non-abrasive cleaning product, then dry

thoroughly with a soft cloth. Do not use rough abrasive

material or sharp metal scrapers as these could

scratch the surface and cause the glass to crack.

For more thorough cleaning purposes, the oven door

may be removed:

1. Open the oven door fully (

see diagram

2. Use a screwdriver to lift up and turn the small levers

located on the two hinges (

see diagram

3. Grip the door on the two

outer sides and close it

approximately half way. Pull the

door towards you, lifting it out

of its slot (

see diagram

). To

replace the door, reverse this

sequence.

Inspecting the seals

Check the door seals around the oven regularly. If the

seals are damaged, please contact your nearest

Service Centre (

see Assistance

). We recommend that

the oven is not used until the seals have been

replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the

glass cover of the

lamp-holder.

2. Unscrew the

light bulb and

replace it with a

similar one:

Wattage 25 W,

cap E 14.

3. Replace the

glass cover (

see

diagram

Side and rear catalytic liners*

These are panels coated with a special enamel, which

is able to absorb the fat released by food as it cooks.

This enamel is quite strong, so that the various

accessories (racks, dripping pans, etc.) can slide

along them without damaging them. White marks may

appear on the surfaces; these are not a cause for

concern.

Nevertheless, the following should be avoided:

- scraping the enamel with sharp objects (a knife, for

example);

- using detergents or abrasive materials.

Care and maintenance

Only available in certain models.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint SX 638 CK Mode d'emploi Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Fours Hotpoint SX 638 CK