Hotpoint RGA724 Manuel d'utilisateur télécharger pdf (Page 17)

Burner Grates

Grates should be washed regularly and after

spillovers. Wash them in hot, soapy water and

rinse with clean water.

After cleaning, dry thoroughly by putting

them in a warm oven for a few minutes.

Don’t put the grates back on the range

while they are wet. When replacing the

grates, be sure they’re positioned securely

over the burners.

To get rid of burned-on food, place the

grates in a covered container (or plastic

bag) with 1/4 cup ammonia to loosen

the soil. Then scrub with a soap-filled

scouring pad if necessary.

Although they’re durable, the grates will

gradually lose their shine, regardless of

the best care you can give them. This is

due to their continual exposure to high

temperatures.

Do not operate a burner for an extended

period of time without cookware on the

grate. The finish on the grate may chip

without cookware to absorb the heat.

Care and cleaning of the range.

ge.com

Be sure electrical power is off and all surfaces are cool before cleaning any part of the range.

Proper care and cleaning are important so your range will give you efficient and satisfactory service. Follow these

directions carefully in caring for your range to assure safe and proper maintenance.

Lift-Up Cooktop

Clean the area under the cooktop often. Built-up

soil, especially grease, may catch on fire.

To make cleaning easier, the cooktop

may be lifted up and propped open.

Be sure all burners are turned off before

raising the cooktop. Then remove the

grates.

Grasp the two front burner wells and lift

the cooktop up and prop it open with

the prop rod provided. Be careful of the

pilots when the cooktop is up.

After cleaning underneath the cooktop

with hot, soapy water and a clean cloth,

hold the cooktop up, return the prop

rod to its storage position and lower the

cooktop until it snaps into position. Be

careful not to pinch your fingers.

If your range is removed for cleaning, servicing or any reason, be sure the anti-tip

device is re-engaged properly when the range is replaced. Failure to take this

precaution could result in tipping of the range and cause injury.

How to Remove the Range for Cleaning and Servicing

Follow these steps to remove the range

for servicing or cleaning hard to reach

surfaces.

Shut off the gas supply to the range.

Disconnect the electrical supply to

the range.

Disconnect the gas supply tubing to

the range.

Slide the range forward to free the

range foot from the Anti-Tip bracket.

See the Installation Instructions for

the location of the bracket.

Reverse these steps to re-install the

range. If the gas line has been

disconnected, check for gas leaks

after re-connection. See the

Installation Instructions for the gas

lead test method.

NOTE: A trained technician should make the gas

installation, disconnection and re-connection of the

gas supply to the appliance.

Safety Instructions Operating Instructions Care and Cleaning Installation Instructions Troubleshooting Tips Consumer Support

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Hotpoint RGA724 Manuel d'utilisateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Radio Hotpoint RGA724