Hotpoint MS 998 IX H Guide d'utilisation et d'entretien télécharger pdf (Page 4)

SAFETY INSTRUCTIONS

IMPORTANT TO BE READ

AND OBSERVED

Before using the appliance

carefully read these safety

instructions.

Keep them close at hand for

future reference.

These instructions and the

appliance itself provide

important safety warnings, to be

observed at all times.

The manufacturer declines any

liability for failure to observe

these safety instructions, for

inapropriate use of the appliance

or incorrect setting of controls.

SAFETY WARNINGS

Very young (0-3 years) and

young children (3-8 years) shall

be kept away from the appliance

unless continuously supervised.

Children from 8 years old and

above and persons with reduced

physical, sensory or mental

capabilities or lack of experience

and knowledge can use this

appliance only if they are

supervised or have been given

instructions on safe use and

understand the hazards

involved. Children must not play

with the appliance. Cleaning and

user maintenance must not be

carried out by children without

supervision.

WARNING: The appliance and

its accessible parts become hot

during use, children less than 8

years of age shall be kept away

unless continuously supervised.

WARNING: Avoid touching

heating elements or interior

surface - risk of burns.

Keep clothes or other ammable

materials away from the

appliance, until all the

components have cooled down

completely.

Never leave the appliance

unattended during food drying.

Overheated oils and fats catch

re easily. Always be vigilant

when cooking foods rich in fat,

oil or when adding alcohol (e.g.

rum, cognac, wine) - risk of re.

Use oven gloves to remove pans

and accessories, taking care not

to touch the heating elements.

At the end of cooking, exercise

caution when opening the door,

by letting the hot air or steam

exit gradually before accessing

the appliance.

Do not obstruct hot air vents at

the front of the oven.

If the appliance is suitable for

probe usage, only use a

temperature probe

recommended for this oven.

PERMITTED USE

This appliance is solely for

domestic, not professional use.

Do not use the appliance

outdoors.

Do not store explosive or

ammable substances such as

aerosol cans and do not place

or use gasoline or other am-

mable materials in or near the

appliance: a re may break out

if the appliance is inadvertently

switched on.

CAUTION: The appliance is

not intended to be operated

by means of an external timer

or separate remote controlled

system.

No other use is permitted (e.g.

heating rooms).

INSTALLATION

Installation and repairs must be

carried out by a qualied

technician, in compliance with

the manufacturer’s instructions

and local safety regulations. Do

not repair or replace any part of

the appliance unless specically

stated in the user manual.

Children should not perform

installation operations. Keep

children away during

installation. Keep the packaging

materials (plastic bags,

polystyrene parts, etc.) out of

reach of children, during and

after the installation.

The appliance must be handled

and installed by two or more

persons. Use protective gloves

to unpack and install the

appliance.

After unpacking the appliance,

make sure that it has not been

damaged during transport. In

the event of problems, contact

the dealer or your nearest After-

sales Service.

The appliance must be

disconnected from the power

supply before any installation

operation.

During installation, make sure

the appliance does not damage

the power cable.

Only activate the appliance

when the installation has been

completed.

Carry out all cabinet cutting

works before tting the

appliance in the furniture and

carefully remove all wood chips

and sawdust.

After installation, the bottom of

the appliance must no longer be

accessible.

Do not obstruct the minimum

gap between the worktop and

the upper edge of the oven.

Only remove the oven from its

polystyrene foam base at the

time of installation.

ELECTRICAL WARNINGS

For installation to comply with

current safety regulations, an

omnipolar switch with minimum

contact gap of 3mm is required

and the appliance must be

earthed.

If the tted plug is not suitable

for your socket outlet, contact a

qualied technician.

The power cable must be long

enough to connect the

appliance, once tted in its

housing, to the main power

supply. Do not pull the power

supply cable.

If the power cable is damaged,

replace with an identical one.

The power cable must only be

replaced by a qualied

technician in compliance with

the manufacturer instruction

and current safety regulations.

1 2 3 4 5 6 7 8 9 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Hotpoint MS 998 IX H Guide d'utilisation et d'entretien Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Non Hotpoint MS 998 IX H