Hotpoint PKL 642 D2/IX/HA Mode d'emploi télécharger pdf (Page 4)

INSTALLATION

TECHNICAL INFORMATION FOR THE INSTALLER

• Use protective gloves for handling, preparing and installing the product.

• This product can be embedded in a worktop 20 ÷ 60 mm thick.

• If there is no oven beneath the hob, insert a separator panel that has a surface at least equal to the opening in the work surface. This panel must

be positioned at a maximum distance of 150 mm below the upper surface of the work surface but, in no case less than 20 mm from the bottom

of the hob. In the case that you intend to install an oven beneath the hob, make sure that it is equipped with a cooling system. The manufacturer

declines all liability if another brand oven is installed beneath the hob.

DIMENSIONS AND DISTANCES TO BE MANTAINED

510 mm

600 mm

41,5 mm

555 mm

55 mm

475 mm

750mm

100mm

50mm

NOTE: if the distance “A” between the wall cabinets is between 600 mm and 730 mm, the height “B” must be a minimum of 530 mm.

if the distance “A” between the wall cabinets is greater than the width of the hob, the height “B” must be a minimum of 400 mm.

In case of installation of a hood above the hob, please refer to the hood instructions fot the correct distance.

ASSEMBLY

After having cleaned the perimeter surface, apply the supplied gasket to the hob as shown in the

gure.

Position the hob in the worktop opening made respecting the dimensions indicated in the Instruction.

NOTE: the power supply cable must be long enough to permit its upward extraction.

To secure the hob, use the brackets (A) provided with it. Fit the brackets into the relevant bores shown by the arrow and fasten them by means of

their screws in accordance with the thickness of the worktop (see the following gures).

20 mm 40 mm

30 mm 60 mm

GAS CONNECTION

• Connect elbow (A)* or (B)* supplied with to the hob inlet main pipe and interpose the washer (C) supplied, in

compliance with EN 549.

* Use elbow (A) for France and elbow (B) for all other destinations.

• After connection to the gas supply, check for leaks with soapy water. Light up the burners and turn the knobs from

max position to minimum position

to check ame stability.

1 2 3 4 5 6 7

Pas de commentaire

Hotpoint PKL 642 D2/IX/HA Mode d'emploi Page 4