Hotpoint WDL 520 P (UK).C Mode d'emploi télécharger pdf (Page 2)

2

GB

Installation

2. If the floor is not perfectly level, com-

pensate for any unevenness by tightening

or loosening the adjustable front feet (see

figure); the angle of inclination, measured

according to the worktop, must not exceed

2°.

Levelling your appliance correctly will provi-

de it with stability and avoid any vibrations,

noise and shifting during operation. If it is

placed on a fitted or loose carpet, adjust

the feet in such a way as to allow enough

room for ventilation beneath the washing

machine.

Electric and water connections

Connecting the water inlet hose

1. Connect the supply

pipe by screwing it

to a cold water tap

using a 3/4 gas thre-

aded connection (see

figure). Before per-

forming the connec-

tion, allow the water

to run freely until it

is perfectly clear.

2. Connect the other

end of the water inlet

hose to the washing

machine,

screwing it onto the

appliance’s cold water

inlet, situated on the

top right-hand side

on the rear of the

appliance (see figure).

3. Make sure there are no kinks or bends in

the hose.

! The water pressure at the tap must be

within the values indicated in the Technical

details table (on the page 5).

! If the water inlet hose is not long enough,

contact a specialist store or an authorised

serviceman.

! Ensure that the supply taps are allowing

water through. Old taps may seize in the

closed position and thus prevent water

reaching the machine.

! Keep this instruction manual in a safe place for

future reference. Should the appliance be sold,

transferred or moved, make sure the instruction

manual accompanies the washing machine to inform

the new owner as to its operation and features.

! Read these instructions carefully: they contain

vital information on installation, use and safety.

Unpacking and levelling

Unpacking

! This is a separate

part of the polysty-

rene base and should

be removed with the

base.

! IMPORTANT check

when unpacking your

machine.

1. Unpack the washing

machine.

2. Check whether the

washing machine has

been damaged du-

ring transport. If this

is the case, do not

install it and contact

your retailer.

3. Remove the 4 pro-

tective screws and the rubber bush with the

respective spacer, situated on the rear of

the appliance (see also the installation lea-

flet).

4. Seal the gaps using the plastic plugs pro-

vided.

5. Keep all the parts: you will need them

again if the washing machine needs to be

moved to another location.

! Packaging materials are not children’s toys.

Levelling

Your machine may make a considerable amount

of noise if the two front feet have not been

adjusted correctly.

1. Install the washing

machine on a flat

sturdy floor, without

resting it up against

walls, furniture cabi-

nets or other.

1 2 3 4 5 6 7 ... 15 16

Commentaires sur ces manuels

Pas de commentaire