Hotpoint CM 7945 IX A Mode d'emploi télécharger pdf (Page 15)

1. The machine is factory-set to make coffee with a standard taste. You can choose coffee with the

following tastes: extra-mild, mild, standard, strong or extra-strong, with the option of using pre-

ground coffee. To choose the desired taste, press the button (B3) (Figure 8) repeatedly until the

required taste is displayed.

2. Place 1 cup under the coffee spouts if you wish to make 1 coffee (Figure 9) or 2 cups for 2 coffees

(Figure 9). For a creamier coffee, lower the coffee spout as near as possible to the cups (Figure 10).

3. Press button (B4) (Figure 11) to select the type of coffee desired: espresso, small cup, medium

cup, large cup, mug.

Press button (B8) (Figure 12) to make 1 coffee, or button (B9) (Figure 13) to make 2 coffees.

The machine grinds the coffee beans and then runs off the coffee.

After running off the pre-set quantity of coffee, the machine automatically stops run-off and then

empties the coffee grounds into the grounds container.

4. After a few seconds, the machine is once again ready for use.

5. To switch off the machine, press the on/stand-by button (A7) (Figure 1). (Before switching off, the

machine runs an automatic rinse cycle: beware of the danger of burns).

N.B.:

• If coffee run-off is too slow or incomplete, refer to chapter ADJUSTING THE COFFEE GRINDER.

• If coffee run-off is too quick and the coffee is not creamy enough, refer to chapter ADJUSTING THE

COFFEE GRINDER.

• Tips for hotter coffee:

- proceed as described in chapter CHANGING AND SETTING MENU PARAMETRS, function Rinsing;

- do not use very thick cups as they absorb too much heat unless pre-heated in advance;

- use pre-heated cups, rinsing them with hot water.

• You can interrupt run-off any time by pressing the previously selected button again.

• As soon as run-off is finished, to increase the amount of coffee in the cup, simply press and hold the

previously selected button within 3 seconds of completion of run-off).

• When the display shows FILL TANK! the water tank must be filled, otherwise the machine will not

prepare any coffee. (The tank may still contain some water; this is normal).

• Every 14 single coffees (or 7 doubles) made, the display shows the message EMPTY GROUNDS

CONTAINER!. To clean, open the service door on the front by pulling the spout (Figure 16), then

remove the drip tray (Figure 17) and clean it.

When cleaning the machine, always fully remove

the drip tray.

• When removing the drip tray, the grounds

container MUST be emptied. If this is not

done, the machine may clog up.

• The water tank must never be pulled out

during coffee run-off. If the tank is removed at

this point, the machine cannot make the

coffee and will display the message: GROUND

TOO FINE ADJUST MILL! PRESS followed

by FILL TANK!. Check the water level in the

tank and replace in the machine. To restart the

machine, insert the water spout if not already

inserted (Figure 6), press (B7) and the display shows HOT WATER. PRESS . Press (B7)

within a few seconds, let water run off from the spout for around 30 seconds. After run-off, the

machine display automatically reverts to the programmed standard settings.

• The machine may require you to repeat the operation several times; this is in order to eliminate any

air in the hydraulic circuit.

• If the above described operation is not carried out correctly or if the machine is switched off, the

display may revert to showing the programmed standard settings, even if in actual fact the problem

persists.

Making coffee (using coffee beans)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Hotpoint CM 7945 IX A Mode d'emploi Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Cafetières Hotpoint CM 7945 IX A