Hotpoint TFA34 Manuel d'utilisateur télécharger pdf (Page 14)

How to remove and clean the fluff filter

Position of filter

To remove the filter

A very important part of your dryer is the fluff filter at the

front edge of the drum. It’s there to trap the particles of

lint and fluff which are normally blown away when

clothes are dried on the washing-line.

if the filter is allowed to become blocked, the passage of

warm air through the drum will be severely restricted.

This means your clothes will take much longer than

normal to dry and the cost of drying them will be

increased. it may also damage your dryer.

Small items, e.g. babies socks, may fall onto the filter.

These should be removed so that the filter is not

restricted.

Grip the centre rib and pull the filter upwards and

forwards through the door seal (see diagram).

Open the filter, and remove the fluff that has collected on

the inside.

Wash or vacuum clean the filter occasionally.

Don’t be alarmed by the amount of fluff you may find on

the filter. It’s part of the wearing, washing and drying

process.

It is essential that the filter is replaced correctly. It must be

fitted so that the symbols, shown on the filter above, face

towards the front of the dryer. Ensure the filter is fully

located into the tumble dryer duct.

WARNING: NEVER USE SHEET FABRIC

CONDITIONER. IT MAY FALL INTO THE

FILTER AND RESTRICT THE AIRFLOW

THROUGH THE DRYER

WARNING: DO NOT OPERATE THE DRYER

WITHOUT CLEANING THE FILTER AFTER EACH

DRYING CYCLE. FAILURE TO CLEAN THE FILTER

MAY RESULT IN A FIRE HAZARD.

WARNING: DO NOT OPERATE THE DRYER

WITHOUT THE FILTER IN POSITION.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Hotpoint TFA34 Manuel d'utilisateur Page 14