Hotpoint HKID 630 LD C Mode d'emploi télécharger pdf (Page 10)

EN 10

Control panel warnings

Residual heat indicator

The hob is tted with a residual heat indicator for each cooking zone. These indicators alert the user when cooking zones are still hot.

If the display shows , the cooking zone is still hot. If the residual heat indicator of a given cooking zone is lit, that zone can be used,

for example, to keep a dish warm or to melt butter.

When the cooking zone cools down, the display goes off.

Incorrect or missing pot indicator

If you are using a pot that is not suitable, not correctly positioned or not of the correct dimensions for your induction hob, the message “no

pot” will appear in the display (see gure at side). In these situations it is recommended to reposition the pot on the hob surface until you

nd the position of operation. If no pot is detected within 60 seconds, the hob switches off.

Fast boil function (Booster where it is available)

This function, only present on some cooking zones, makes it possible to exploit the hob’s maximum power (for example to bring water to the boil very quickly).

To activate the function, press the “+” button until “P” appears on the display. After 5 minutes’ use of the booster function, the appliance automatically sets the

zone to level 9.

FLEXI

This function is used in case of big pots that the single zone can not satised, ex, sh, big pot for meat.

In order to active the FLEXI/CONNEXTION ZONE, please press on + and - buttons simultaneously as shown

in the picture below.

“Power management” (Function where it is available)

Thanks to the “Power management” function, the user can set the maximum power the hob can reach, as required.

This setting is possible at any time and is maintained until the next change.

By setting the required maximum power, the hob automatically adjusts distribution in the various cooking zones, ensuring that this limit is never exceeded; with

the advantage of also being able to manage all the zones simultaneously, but without overload problems.

4 maximum power levels are available and showed on display: 2.5 – 4.0 – 6.0 – 7.2 kW (7.2 kW is considered as max power of cooktop).

At the time of purchase, the hob is set to maximum power.

After plugging the appliance into the electrical socket, in the rst 60 seconds it is possible to set the required power level by running the following points:

Step Control panel Display

Press for approximately 3 seconds both Power

management button (step 1).

Press the Power Management button (step 2) to conrm

the previous step.

The display shows .

Press to set the chosen level amongst the different options

available.

The light comes on together with the in-use lights for the

individual cooking zones.

Press the Power Management button (step 4) to conrm

the previous step.

The display shows the set level which flashes for

approximately 2 seconds; after which the hob emits an

acoustic signal and then turns itself off; it is now ready for use.

In case of an error when setting the power, the symbol appears in the middle and an acoustic signal sounds for about 5 seconds. In this case repeat the

conguration procedure from the beginning. If the error occurs again, contact the After-Sales Service.

During normal use, if the user tries to increase the maximum available power level when reached, the level of the zone in use ashes twice and an acoustic

signal sounds.

To obtain a higher power in that zone, it is necessary to manually decrease the power level of one or more already active cooking zones.