Hotpoint RGB506 Manuel d'utilisateur télécharger pdf (Page 16)

ADJUST THE OVEN THERMOSTATÑ

DO IT YOURSELF!

You may feel that your new oven cooks differently

than the one it replaced. We recommend that you

use your new oven for a few weeks to become more

familiar with it, following the times given in your

recipes as a guide.

If you think your new oven is too hot or too cold,

you can adjust the thermostat yourself. If you think

it is too hot, adjust the thermostat to make it cooler.

If you think it is too cool, adjust the thermostat to

make it hotter.

We do not recommend the use of inexpensive

thermometers, such as those found in grocery stores,

to check the temperature setting of your new oven.

These thermometers may vary 20Ð40 degrees.

To Adjust the Thermostat:

(appearance may vary)

1. Check to be sure the OVEN CONTROL knob is in

the OFF position.

2. Pull the knob straight off the shaft.

3. On the back of the knob there are a series of 5 to

7 small grooves. Note the position of the pointer

(located in the middle groove). Loosen the 2 screws

on the back of the knob.

NOTE: If the knob does not have 2 screws, it is

not adjustable.

4. To increase or decrease the temperature, move

the pointer in the desired direction according to

the R (raise) Ð L (lower) arrow. The temperature

can be adjusted in increments as indicated on the

back of the knob.

5. When the desired adjustment is reached, tighten

both screws.

6. To replace the knob, line up the flat sides of both

the knob and the shaft. Push the knob into place.

DO NOT force the OVEN CONTROL knob onto

the shaft or you may damage the back of the knob.

NOTE: Once an adjustment is made, the OFF

position will vary from the reference mark on the

backguard depending on the amount of adjustment.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Pas de commentaire

Hotpoint RGB506 Manuel d'utilisateur Page 16