Hotpoint RGB506 Manuel d'utilisateur télécharger pdf (Page 33)

The shutter for the oven burner is near the back

wall of the oven and behind the broiler drawer.

CHECK IGNITION OF OVEN BURNER

Your oven is designed to operate quietly and

automatically. To operate the oven, turn the OVEN

CONTROL knob to a setting above 200°F. After

30–90 seconds, the oven burner will ignite and

burn until the set temperature is reached. The

oven burner will continue to cycle on and off as

necessary to maintain the oven at the temperature

indicated by the OVEN CONTROL knob.

Electric ignition models require electrical

power to operate. The oven cannot be lit during a

power outage. Gas will not flow unless the glow

bar is hot.

If the oven is in use when a power outage occurs,

the burner will shut off and cannot be re-lit until

power is restored.

ADJUSTING THE AIR ADJUSTMENT SHUTTER

To determine if the bottom burner flames are

burning properly, first remove the oven bottom

and burner baffle.

To remove the oven bottom:

1. Remove screws holding down rear of oven

bottom.

2. Grasp oven bottom at finger slots on each side.

3. Lift rear of oven bottom enough to clear the

lip of range frame, then pull it out of the oven.

4. Remove the burner baffle so that the burner

flame can be observed.

With the oven bottom removed, properly

adjusted flames should have approximately 1

blue cones and, if range is supplied with natural

gas, should burn with no yellow tipping. (With

most LP gas, small yellow tips at the end of

outer cones are normal.) Flames should not lift

off burner ports. If lifting is observed, gradually

reduce air shutter opening until flames are

stabilized.

(continued next page)

To adjust the air shutter:

To adjust the flow of air to the burner, loosen the

Phillips-head screw and rotate the shutter to

allow more or less air into the burner tube.

If the flame is yellow in color, increase air

shutter opening size. If the flame is a distinct

blue, reduce the air shutter opening size.

To adjust loosen lock screw, reposition air

shutter, and tighten lock screw. Replace oven

bottom.

Lock screw

Air shutter

Orifice hood

Oven burner tube

Air shutter

Lower oven bottom

(removable)

Lower oven baffle

(removable)

Oven bottom

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

Commentaires sur ces manuels

Pas de commentaire

Hotpoint RGB506 Manuel d'utilisateur Page 33

Commentaires sur ces manuels

Produits connexes et manuels pour Radio Hotpoint RGB506