Hotpoint RGB506 Manuel d'utilisateur télécharger pdf (Page 30)

30

INSTALLATION INSTRUCTIONS

(continued)

LIGHT THE PILOTS

(for models equipped with standing pilots)

The range should be installed in its permanent

position before any pilots are lit or adjusted.

Light the Surface Burner Pilots

CAUTION: Make sure the surface burner

control knobs are in the OFF position before

attempting to light the pilots.

1. Raise the cooktop.

2. Light both pilots with a match. When both

pilots are lit, adjust the top pilot adjustment until

the pilots are approximately 1/8

² above the pilot

cage with a very slight yellow tip.

3. To avoid pilot outage, use caution when

closing cooktop after lighting pilots.

Check Surface Burners

To check for proper lighting, push in and turn a

surface burner knob to the LITE position. Each

burner should light within four (4) seconds in

normal operation. Once the burner lights, the

knob should be rotated out of the LITE position.

Try each knob separately until all burner valves

have been checked.

NOTE: Do not leave standing pilot lit in a newly

constructed or remodeled home or apartment

that will be unoccupied for more than a month.

Each pilot flame was adjusted at the factory

to be approximately 1/8² above the pilot cage.

A tinge of yellow appearing at the upper tip is

normal. If you find pilot adjustment is necessary,

follow instructions in this section for adjusting

the surface burner pilots.

5

ELECTRICAL CONNECTIONS

(continued)

Usage Situations where Appliance Power

Cord will be Disconnected Frequently.

Do not use an adapter plug in these situations

because disconnecting of the power cord

places undue strain on the adapter and leads to

eventual failure of the adapter ground terminal.

The customer should have the two-prong

wall receptacle replaced with a three-prong

(grounding) receptacle by a qualified electrician

before using the appliance.

The installation of appliances designed for

mobile home installation must conform with

the Manufactured Home Construction and

Safety Standard, Title 24 CFR, Part 3280

(formerly the Federal Standard for Mobile

Home Construction and Safety, Title 24, HUD,

Part 280) or, when such standard is not

applicable, the Standard for Manufactured

Home Installations, latest edition (Manufactured

Home Sites, Communities and Set-Ups), ANSI

A225.1, latest edition, or with local codes. In

Canada, mobile home installation must be in

accordance with the current CAN/CSA

Z240/MH Mobile Home Installation Code.

Electric Disconnect

1. Locate disconnect plug on the range back.

2. Pinch sides of connector and pull out of

range back.

B

SEAL THE OPENINGS

Seal any openings in the wall behind the range

and in the floor under the range when hookups

are completed.

4

1/8² Above

the pilot

cage

Pilot cage

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Commentaires sur ces manuels

Pas de commentaire